Prerequisites

Pure needs to be able to access the internet for this part to work, as it will read some of the customer specific configuration from the Atira wiki.

Pure maintenance mode

As this is the first time Pure is started, it will enter maintenance mode to run the required installation jobs.

The following will be shown in the log file when Pure enters maintenance mode

[INFO  20131007095644 ootManager: WebBootSequenceInteractionManager] ------------------------------------------------------------------------------
[INFO  20131007095644 ootManager: WebBootSequenceInteractionManager] | Entering maintenance mode!                                                 |
[INFO  20131007095644 ootManager: WebBootSequenceInteractionManager] | Go to http://<your server>/admin/prestartup/maintenance.xhtml              |
[INFO  20131007095644 ootManager: WebBootSequenceInteractionManager] | Password: 123ab45c-67de-8910-f2g3-h9900i80j509                             |
[INFO  20131007095644 ootManager: WebBootSequenceInteractionManager] ------------------------------------------------------------------------------

Now open the URL http://<your server>/admin/prestartup/maintenance.xhtml in a browser and use the password from the log file to login.

This password is auto generated every time Pure starts.

Configuration File upload 

In the Pure startup step you will be prompted to upload the configuration zip file which has been provided by Elsevier or one of your colleagues.

Once the file has been uploaded, press continue to verify and continue

Any settings not defined in the configuration file will need to be entered manually see below (General configuration)

General configuration

Then we need to setup the general configuration of Pure.

All the values can be changed inside Pure after the installation (except System UI locales and Supported submission locales).